'67 Front Spindle Steering Arm Mount Nuts

[David H.]

Re: '67 Front Spindle Steering Arm Mount Nuts

Leif

Below are torque specs from Van Steel's web site.

Dave

C2/3 Corvette Typical Torque Specs

Part # Description Torque Spec

SB-06 Sway Bar Frame Mount Bolts 20 ft ft/lbs

FS-27K Lower A-Arm 2 Hole Plate 70 ft/lbs

FS-37 Front Upper Backing Plate Bolt 130 ft/lbs

FS-38K Front Lower BA Bolts 55-60 ft/lbs

FS-39K Front Lower BA Bolts 85-90 ft/lbs

ST-03 Upper Idler Arm Bolt 35-40 ft/lbs

ST-04 Lower Idler Bolt 35-40 ft/lbs

GB-32 Steering Box Bolts 35-40 ft/lbs

FS-06 Upper A-Arm Bushing Bolts 35 ft/lbs

FS-09 Alignment Stud Nuts 50 ft/lbs

FS-23K Lower A-Arm Bushing Bolts 70 ft/lbs

FS-28K Lower A-Arm Rear Bolt 100 ft/lbs

TA-22 T-Arm Bolt Kit NO Torque Spec

TA-23S T-Arm Bolt & Shim Kit NO Torque Spec

SR-17K Eccentric Bolts 100 ft/lbs

FC-09PK Pinion Bushing 70 ft/lbs

FC-09R Pinion Bushing 70 ft/lbs

SR-13K Strut Rod Bracket Bolts 35-40 ft/lbs

SR-20 Upper Shock Mount Bolts 55-60 ft/lbs

SG-47 7/16-20 Nuts 35 ft/lbs

SG-54 7/16-20 Nuts 35 ft/lbs

SG-30K Diff X-Member Bolts 50-55 ft/lbs

RB-31K Caliper Bolts 70 ft/lbs

FC-11k Pinion Bracket Bolts 50 ft/lbs

VS-97456 Alignment Studs 35 ft/lbs

[Leif A.]

Re: '67 Front Spindle Steering Arm Mount Nuts

Dave,
Thanks for the additional information...always helpful.

[Leif A.]

Re: '67 Front Spindle Steering Arm Mount Nuts

Just a quick follow-up. I received my spindle bolts and nuts a couple of days ago and decided to install today. Not a bad job at all. I took my time and did the passenger side first...one hour and forty five minutes. Driver side forty minutes. Glad to have it done...all torqued to 70 lb ft. Again, thanks for everyone's input.