Hi:
As we are all aware the process of reverting a made-up side-pipe car to the correct under car exhaust requires collecting all of the requisite pieces to make the switch. Fair enough and relatively strategy forward. However, I have found several vendors who are selling a pair of parts called "rocker molding mount brackets". See the example photo below:
Screen Shot 2016-04-22 at 12.31.10 PM.png
Apparently, the idea here is to rivet these to the front edge of the fiberglass fender tab. (The one that was removed when the side pipes were installed.) This one----
Screen Shot 2016-04-22 at 12.37.40 PM.png
My question is this: Is this just someones idea of a way to remount the fender tabs or were these actually used at the factory.... I did not see anything in the AIM ('67). But I may have missed something ---
Any ideas on this one?
Thanks!!!
Bill
As we are all aware the process of reverting a made-up side-pipe car to the correct under car exhaust requires collecting all of the requisite pieces to make the switch. Fair enough and relatively strategy forward. However, I have found several vendors who are selling a pair of parts called "rocker molding mount brackets". See the example photo below:
Screen Shot 2016-04-22 at 12.31.10 PM.png
Apparently, the idea here is to rivet these to the front edge of the fiberglass fender tab. (The one that was removed when the side pipes were installed.) This one----
Screen Shot 2016-04-22 at 12.37.40 PM.png
My question is this: Is this just someones idea of a way to remount the fender tabs or were these actually used at the factory.... I did not see anything in the AIM ('67). But I may have missed something ---

Any ideas on this one?
Thanks!!!
Bill
Comment