I am refinishing my 68 smog pulley, any suggestions on the correct color and best paint to use? I've seen used ones in Black, and Grey. thanks for any suggestions. Steve
Best paint for my 68 427 Smog Pulley?
Collapse
X
-
Re: Best paint for my 68 427 Smog Pulley?
The original finish, I believe (it is those pesky 1968s that give me pause), dark phosphate. this color can range from gray to black, but it has the sparkles in it. Paint will fool some of the people some of the time, but not the NCRS judges.Terry- Top
-
Re: Best paint for my 68 427 Smog Pulley?
Steve,
Contact Bill Hodell at billhodel@sbcglobal.net That email may be dated but he advertises in the Driveline. He is the smog pump supplier to a large number of NCRS cars. Highly recommended.
TerryTerry Buchanan
Webmaster / Secretary - Heart of Ohio Chapter www.ncrs.org/hoo
Corvettes Owned:
1977 Coupe
1968 Convertible 427/390 (L-36) Chapter Top Flight 2007, Regional Top Flight 2010, National Top Flight 2011
2003 Electron Blue Coupe
2019 Torch Red Grand Sport Coupe- Top
Comment
-
Re: Best paint for my 68 427 Smog Pulley?
Give an IM to member Grant Wong.
He sells parkerizing solution - I use it on all of the hood latch mechanism and the metal toe board heat shields.
it is fairly dark in color (manganese) - you can also darken by using a cold dip blackening solution (black oxide) prior to the hot dip in the parkerizing stuff.
Bill- Top
Comment
-
Re: Best paint for my 68 427 Smog Pulley?
Hi Steve;
I purchased a parkerizing concentrate from a local gun shop, as per the instructions mixed with distilled water and heated the solution with a hot plate, worked great on the smog pulley and hood catches.
Bob- Top
Comment
Comment