Clutch head screw source???? - NCRS Discussion Boards

Clutch head screw source????

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Philip P.
    Expired
    • February 28, 2011
    • 558

    #16
    Re: Clutch head screw source????

    John.. I was trying to get an idea without removing the screw, but in the end I did remove it just to make sure and it is as you state 1 inch from the bottom to the tip. It was hard for to get a good measurement while it was installed around the hood bracket.
    Don.. the only thing about your solution is to make sure the thread length in enough to tighten it.
    Next time I am wandering a wrecking yard I think I will be on the look out for clutch head screws on old GM cars/trucks.
    Phil

    Comment

    • John F.
      Extremely Frequent Poster
      • March 23, 2008
      • 2408

      #17
      Re: Clutch head screw source????

      Don, I had recommended you shave a little off since you said you had replacement panels that were thicker. My original 62 from the factory looks like this. Maybe your 60 is different.
      Attached Files

      Comment

      Working...
      Searching...Please wait.
      An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

      Please push the back button and reload the previous window.'
      An unexpected error was returned: 'Your submission could not be processed because the token has expired.

      Please push the back button and reload the previous window.'
      An internal error has occurred and the module cannot be displayed.
      There are no results that meet this criteria.
      Search Result for "|||"