Re: C1 Clutch adjustment
Jerry, good catch.....Here it is: https://www.forums.ncrs.org/showthre...-bar-alignment
Looking at David's photo in the above link, and the description, it's obvious the fork is too far forward. The clutch pedal rod is not connected, and the gorilla spring lever end of the Zbar is not pointing slightly forward as it should. The spring can look that way on either side of the high point/over center "arc" of that lever.
Now I'm wondering if the bell housing fork "Pivot Ball" is too long. ???
Maybe the original clutch was a pass car "flat finger" type, and they used the 1 1/4" TO bearing, and made up for it by installing a long BH fork pivot ball stud. ???
Rich
Jerry, good catch.....Here it is: https://www.forums.ncrs.org/showthre...-bar-alignment
Looking at David's photo in the above link, and the description, it's obvious the fork is too far forward. The clutch pedal rod is not connected, and the gorilla spring lever end of the Zbar is not pointing slightly forward as it should. The spring can look that way on either side of the high point/over center "arc" of that lever.
Now I'm wondering if the bell housing fork "Pivot Ball" is too long. ???
Maybe the original clutch was a pass car "flat finger" type, and they used the 1 1/4" TO bearing, and made up for it by installing a long BH fork pivot ball stud. ???
Rich
Comment