Re: 2 Bar Knock Off Wheels?
At a swap meet recently, I bought a Two Bar "Nut" and adaptor. The center emblem says "Chevrolet" and has a Bow Tie Emblem in the center. The adaptor is gear Drive and NOT Pin Drive. This all appears to be old original stuff. What do I have? Is it Corvair or ? Should I put it in a Glass Display case or use it as a door stop?
Years ago, in the mid '70s, I bought a set of Two Bar "Nuts" with seperate center emblems. It appeared the Nuts were GM but I am almost sure the emblems were Reproductions. I had a restored '63 FI Daytona Blue Roadster that I showed in the early '80s with K.O. Wheels using these Two bar "Nuts". It really looked Great. I took the car to the Regional NCRS Meet at Bend Oregon in 1988. Lots of comments even though there was a question if this was really correct.
Again, any comments as to what I recently bought would be appreciated.
Chris
At a swap meet recently, I bought a Two Bar "Nut" and adaptor. The center emblem says "Chevrolet" and has a Bow Tie Emblem in the center. The adaptor is gear Drive and NOT Pin Drive. This all appears to be old original stuff. What do I have? Is it Corvair or ? Should I put it in a Glass Display case or use it as a door stop?
Years ago, in the mid '70s, I bought a set of Two Bar "Nuts" with seperate center emblems. It appeared the Nuts were GM but I am almost sure the emblems were Reproductions. I had a restored '63 FI Daytona Blue Roadster that I showed in the early '80s with K.O. Wheels using these Two bar "Nuts". It really looked Great. I took the car to the Regional NCRS Meet at Bend Oregon in 1988. Lots of comments even though there was a question if this was really correct.
Again, any comments as to what I recently bought would be appreciated.
Chris
Comment