67 issues - NCRS Discussion Boards

67 issues

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Ken A.
    Very Frequent User
    • July 31, 1986
    • 929

    #16
    Re: 67 issues

    Quick test for distributor:Unplug harness and connect AC voltmeter to output leads. Crank motor & should see min of 1.4 volts from distributor. If less, replace pickup coil.

    Comment

    • Jack H.
      Extremely Frequent Poster
      • April 1, 1990
      • 9906

      #17
      Re: 67 issues

      One other nuissance I've seen here/there, is the discrete ground lug to the TI amp is shown being attached by simply 'sandwiching' it between the amp case and the mounting screw... The case of the TI amplifier is painted and in rare cases you wind up with poor ohmic contact.

      The solution I've used is to place a small star washer between the amp case and the ground lug to 'bite' through paint and insure a solid ground contact...

      Comment

      • Ken A.
        Very Frequent User
        • July 31, 1986
        • 929

        #18
        Re: 67 issues

        An original amp & the current reproduction were spot faced bare aluminum at all 3 mounting points. A star washer is shown in the assembly manual on the ground lug terminal. If yours is painted, then it was repainted at some point.

        Comment

        • Michael H.
          Expired
          • January 29, 2008
          • 7477

          #19
          Re: 67 issues

          Originally posted by Ken Anderson (10232)
          An original amp & the current reproduction were spot faced bare aluminum at all 3 mounting points. A star washer is shown in the assembly manual on the ground lug terminal. If yours is painted, then it was repainted at some point.
          I agree, original amps had no paint in the area described. However, amp's sold in service years later did. purchased a few new amps from Delco in the mid 80's and the area was painted black.

          Comment

          Working...
          Searching...Please wait.
          An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

          Please push the back button and reload the previous window.'
          An unexpected error was returned: 'Your submission could not be processed because the token has expired.

          Please push the back button and reload the previous window.'
          An internal error has occurred and the module cannot be displayed.
          There are no results that meet this criteria.
          Search Result for "|||"