Rotor Runout - NCRS Discussion Boards

Rotor Runout

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Michael C.
    Very Frequent User
    • January 9, 2013
    • 332
    #1

    Rotor Runout

    I've read many posts regarding rotor runout here and other forums. And watch several videos. Only one instruction that the rear hubs/rotors should be raised to approximately riding height before measuring runout. Is this a requirement? If yes, does this mean the front should also be raised? 69 BB.
    Thanks
    Mike
    Tags: 1969, rotor runout
      • Top
    • Jim L.
      Extremely Frequent Poster
      • September 30, 1979
      • 1817
      #2
      The probable reason for raising the rear hubs is to prevent U-joint binding as the rotor is turned during the measuring process. No such requirement exists for the front hubs..
        • Top

        Comment

        • Michael C.
          Very Frequent User
          • January 9, 2013
          • 332
          #3
          Thanks for the quick reply Jim. One less concern to check off the list.
            • Top

            Comment

            Previous template Next
            Working...
            Searching...Please wait.
            An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

            Please push the back button and reload the previous window.'
            An unexpected error was returned: 'Your submission could not be processed because the token has expired.

            Please push the back button and reload the previous window.'
            An internal error has occurred and the module cannot be displayed.
            There are no results that meet this criteria.
            Search Result for "|||"