I'm trying to install this switch for a friend of mine and I'm have trouble keeping the interlocking part of the switch engaged while I'm tightening the small bolt that goes through the hole in the picture. When I tighten this bolt, the interlocking part stays in place, however when I go to tighten it to lock it in place, the interlocking section comes loose.
My thought is that maybe the hole in these pictures is a bit too big and it's pulling one side into the switch at an angle which distorts the "squareness" of the switch.
A possible solution is to put a bolt in that's the size of the extended hole and re-tap the other side to fit. Other than that......I got nothing!!
Thoughts on a solution will be appreciated.
Thanks
My thought is that maybe the hole in these pictures is a bit too big and it's pulling one side into the switch at an angle which distorts the "squareness" of the switch.
A possible solution is to put a bolt in that's the size of the extended hole and re-tap the other side to fit. Other than that......I got nothing!!
Thoughts on a solution will be appreciated.
Thanks
Comment