The gasket is missing so although the compartment door latches, it rattles. I purchased the gasket. It is a dense foam about 1/4 inch thick. I need to know if it is correct to use an adhesive on the bottom of the gasket or does it just dry fit in place? Thanks.
-
-
Re: Battery Storage Compartment Gasket
Bill-----
On my 69 the gasket is attached with adhesive. I'm fairly certain that 70 would be the same.In Appreciation of John Hinckley -
Re: Battery Storage Compartment Gasket
I just replaced the original gasket on my 71. It was held in place with adhesive. I did the same on replacement.
JohnComment
-
Re: Battery Storage Compartment Gasket
My original and unrestored 72 has a gasket that is glued on. GaryComment
-
Re: Suggestions on Adhesive
Do you think a spray type would work or something more like a thicker, caulk type. Thanks for the replys.Comment
-
Re: Suggestions on Adhesive
I guess you could use a spray if you mask off the frame to prevent overspray. I used weatherstrip adhesive. Got it at PepBoys for about $5 for a small tube. Applied with a Qtip to both surfaces and installed gasket.
JohnComment
-
Re: Thanks *NM*
Comment
-
Re: Battery Storage Compartment Gasket
Be sure to get the straight piece of foam that is formed around the compartment frame. Some repros are die cut, pre-formed to the compartment shape in one continuous piece. The originals had a definite end.Comment
-
Re: Battery Storage Compartment Gasket
Bill on my original owner 70 the gasket is glued.Comment
Comment