56 7266634 Resistor
What terminal on the headlight switch should the 7266634 resistor be attached to? Also, I believe the ground end of the resistor should be attached to the dash at the hood release fastener, correct?
Thanks for the help!
Thanks for the help!
-
Mark Pugmire
54 Pennant Blue
56 Cascade Green Dual Quad
56 Arctic Blue Dual Quad
66 Nassau Blue 427 L36 Convertible
67 Marlboro Maroon L79 Coupe -
Re: 56 7266634 Resistor
Connection's in the AIM Section F.O.A. 102 Sheet 2NCRS Texas Chapter
https://www.ncrstexas.org/
https://www.facebook.com/profile.php?id=61565408483631 -
Re: 56 7266634 Resistor
And I just happened to have a few pics of one to go along with the AIM diagram......Rich
p.s. I think you mean the radio suppression capacitor, not resistor, correct? 2nd photo big brown cylinder connected to the terminal next to the Red wire going to the Regulator. The other end(Gnd) goes to the brace along with the main harness ground also shown on the diagram 102-2.
P3100003.jpg P3100004.jpg P3100009.jpg P3100007.jpgLast edited by Richard M.; May 3, 2014, 03:59 AM.Comment
-
Re: 56 7266634 Resistor
Richard,
Thanks so very much for the pictures. This is perfect. I had a question originally because my other 56 had it installed incorrectly and I didn't want to duplicate an incorrect configuration. And, yes, you are correct, it is the capacitor, not a resistor. Thanks again for the info.Mark Pugmire
54 Pennant Blue
56 Cascade Green Dual Quad
56 Arctic Blue Dual Quad
66 Nassau Blue 427 L36 Convertible
67 Marlboro Maroon L79 CoupeComment
Comment