70 4 speed interlock cable routing

[Bill L.]

I have the AIM and it shows how to rout the cable. It just seems really close the the clutch fork. (Above the clutch fork) Do I need to manipulate the cable bend for more clearance?

Does this sound about right? Does someone have a picture from underneath showing the routing past the bell housing and around the clutch fork? (May be tough to get a picture I know)

Mine did not have a cable when purchased. As a result I have no reference.

Thanks,


Bill

[Joe L.]

Re: 70 4 speed interlock cable routing

I have the AIM and it shows how to rout the cable. It just seems really close the the clutch fork. (Above the clutch fork) Do I need to manipulate the cable bend for more clearance?

Does this sound about right? Does someone have a picture from underneath showing the routing past the bell housing and around the clutch fork? (May be tough to get a picture I know)

Mine did not have a cable when purchased. As a result I have no reference.

Thanks,


Bill

Bill------


It does run pretty close to the clutch fork. Attached are photos from a 1969 but I believe it's the same as 1970.


DSCN2941.jpgDSCN2942.jpgDSCN2943.jpg

[John H.]

Re: 70 4 speed interlock cable routing

Bill------


It does run pretty close to the clutch fork. Attached are photos from a 1969 but I believe it's the same as 1970.

Joe -

Nice-looking core shake-out plugs .

[Bill L.]

Re: 70 4 speed interlock cable routing

Bill------


It does run pretty close to the clutch fork. Attached are photos from a 1969 but I believe it's the same as 1970.


[ATTACH=CONFIG]50650[/ATTACH][ATTACH=CONFIG]50651[/ATTACH][ATTACH=CONFIG]50652[/ATTACH]

Thank you Joe.

That is exactly what I had. It just seemed maybe it was too close to the fork.

I will continue with the reassembly.

Bill

[Joe L.]

Re: 70 4 speed interlock cable routing

Joe -

Nice-looking core shake-out plugs .

John-----


They're just absolutely DIVINE! They give me pleasure every time I see them.

[Joe L.]

Re: 70 4 speed interlock cable routing

Thank you Joe.

That is exactly what I had. It just seemed maybe it was too close to the fork.

I will continue with the reassembly.

Bill

Bill------


By the way, although the "Mickey-Mouse" clip is not installed, the flange on the cable is fully seated against the bracket. So, the position of the cable is the final, installed position.