I was wondering if anyone has had issues with Trim Parts, Stingray script not following the body contour?
I just went to install my new one and I see that the center area touches the body but the end areas are about 1/16"-1/8" away. If I lay it on the table face down there is an obvious bow to it but it should be straight like my old original one. Now I know that pot metal will bend a certain amount but I've never really had to "finesse" a part like this to fit and I really don't want to break it.
Any ideas are appreciated.
I just went to install my new one and I see that the center area touches the body but the end areas are about 1/16"-1/8" away. If I lay it on the table face down there is an obvious bow to it but it should be straight like my old original one. Now I know that pot metal will bend a certain amount but I've never really had to "finesse" a part like this to fit and I really don't want to break it.
Any ideas are appreciated.
Comment