Poor Vendor Experience
I was referred to Goat Hill Classics by a well known Corvette aftermarket parts supplier. After two initial and cordial phone discussions, I sent a throttle plate/rod assembly for a 57 fuelie for rework and symbol stamping. Four months have now passed and I have not been able to get multiple phone calls answered or returned, same with email. I had hoped to discuss this in person at 2013 Carlisle, but the assigned vendor space was empty. I have since seen other negative internet comments on this vendor.
-
-
Re: Poor Vendor Experience
Bruce, I see you are in Ohio. I'd like to suggest you make a contact with an NCRS member near Long Beach to help get your stuff back, even if it's not done.
Also, never use them again. Many of us have had very bad experience with them.
-
Re: Poor Vendor Experience
Moved this thread out of the Discussion Board Help forum and into the TDB because I think that was where Mr. Beeghly meant to place it. Now I will close it because good advice has been given. Let's hope OP gets his satisfaction if that is possible. If anyone can help Mr. Beeghly please pm or email him.Comment
Comment