Attachment nuts for hood and trunk emblems on a '57 - NCRS Discussion Boards

Attachment nuts for hood and trunk emblems on a '57

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Garry E.
    Very Frequent User
    • September 30, 2002
    • 240

    Attachment nuts for hood and trunk emblems on a '57

    Does anyone know sells the correct attachment nuts for the hood and trunk "Corvette" emblems on a '57...? I've been using a standard, flat speed nut and have been told these are not correct.... I've also been told that the correct nuts have a small rubber washer/gasket under the flat side to prevent leakage through the attachement holes....

    Any thoughts on this.....?

    Garry Eastwood
    #38705
  • Mike M.
    NCRS Past President
    • May 31, 1974
    • 8375

    #2
    Re: Attachment nuts for hood and trunk emblems on a '57

    gary pronesti has the correct speed nuts. mike

    Comment

    • David S.
      Very Frequent User
      • November 30, 1982
      • 310

      #3
      Re: Attachment nuts for hood and trunk emblems on a '57

      Hi Gary,
      Front and rear emblems are two different styles nuts. Only the trunk nuts had the rubber washer. The general did not care if water leaked into the grill area.
      I will try to post picture of my bowtie car.
      Dave
      Attached Files

      Comment

      Working...
      Searching...Please wait.
      An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

      Please push the back button and reload the previous window.'
      An unexpected error was returned: 'Your submission could not be processed because the token has expired.

      Please push the back button and reload the previous window.'
      An internal error has occurred and the module cannot be displayed.
      There are no results that meet this criteria.
      Search Result for "|||"