1972 C3 blower motor help - NCRS Discussion Boards

1972 C3 blower motor help

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Tom L.
    Extremely Frequent Poster
    • October 17, 2006
    • 1439

    1972 C3 blower motor help

    Having a problem with my blower motor. The 3 lower speeds work fine but it doean't operate on high at all. It's an A/C car but it isn't installed at this time, not sure if it matters. Just wondering if there are any areas I should look at before I start digging into the wiring. Thanks!!
  • Dick W.
    Former NCRS Director Region IV
    • June 30, 1985
    • 10483

    #2
    Re: 1972 C3 blower motor help

    Check your high speed blower relay, located on the engine compartment side of the heater box. Check to see if it is getting power, if not, check in the inline fuse located on the left inner fender.
    Dick Whittington

    Comment

    • Tom L.
      Extremely Frequent Poster
      • October 17, 2006
      • 1439

      #3
      Re: 1972 C3 blower motor help

      That would be the relay behind the resistor and kind of under the wiper door actuator right?

      Comment

      • Tom L.
        Extremely Frequent Poster
        • October 17, 2006
        • 1439

        #4
        Re: 1972 C3 blower motor help

        Just following up. Seems the fuse holder on the driver's side fender broke a while back. The barbs that lock the two sides broke off. I guess the previous owner didn't mind the fan not working on high. Replaced the fuse holder and all is good. Thanks Dick!!

        Comment

        Working...
        Searching...Please wait.
        An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

        Please push the back button and reload the previous window.'
        An unexpected error was returned: 'Your submission could not be processed because the token has expired.

        Please push the back button and reload the previous window.'
        An internal error has occurred and the module cannot be displayed.
        There are no results that meet this criteria.
        Search Result for "|||"