57 splash shields???

[Ken G.]

[IMG][/IMG]I received 4 pieces that the seller claimed were splash shields for a 57, the AIM manual is not much help and for the life of me, I cannot sort out how and where they attach. I have replaced the entire front clip so there are no holes to give me any hints. Can anyone help with diagrams or photos? Are these even correct pieces?
Thanks

Ken
[IMG][IMG][IMG][/IMG][/IMG][/IMG]

[Adam S.]

Re: 57 splash shields???

Hi Ken, here is a picture of the drivers side looking down in the area by the brake cylinder on a photo I saved from someones original 57 corvette, hope this helps, AIMS manual should help as well, see attached pict. & good luck, Adam.

[Adam S.]

Re: 57 splash shields???

Hi Ken, here is a view from bottom, as you can see , there is one bolt that attaches to frame as well, you should have that one on your frame for starting point & the three holes on drivers side will attach to edge of large plate to inner fender wall lower edge, good luck , someone may chime in to help as well.....

[Susan M.]

Re: 57 splash shields???

Hi Ken, I am restoring a 57 now and I had to replace 1 spash shield. Your set looks ok; If you go to Corvette Central and search splash sheilds (item 571071) there is a photo of the pieces. They look like yours. Let me know if you need additional input or if Adam's info takes care of it. Regards, Susan

[Ken G.]

Re: 57 splash shields???

Thanks! I will try arranging the pieces of the puzzle and see if it makes sense.

Ken