64 327 Hydraulic lifter/tappet noise. - NCRS Discussion Boards

64 327 Hydraulic lifter/tappet noise.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Michael C.
    Expired
    • January 30, 2008
    • 6

    64 327 Hydraulic lifter/tappet noise.

    My recently rebuilt 327-300 hp with new mild comp cam and all new components runs great until warm when tappet noise starts. Any thoughts?
  • Clem Z.
    Expired
    • January 1, 2006
    • 9427

    #2
    Re: 64 327 Hydraulic lifter/tappet noise.

    Originally posted by Michael Cornwell (48532)
    My recently rebuilt 327-300 hp with new mild comp cam and all new components runs great until warm when tappet noise starts. Any thoughts?
    reset the lash hot and running to start.

    Comment

    • John G.
      Expired
      • January 1, 2006
      • 85

      #3
      Re: 64 327 Hydraulic lifter/tappet noise.

      What Clem said, plus I'd change oil. Might be a little crap from rebuild.

      John G

      Comment

      • Domenic T.
        Expired
        • January 29, 2010
        • 2452

        #4
        Re: 64 327 Hydraulic lifter/tappet noise.

        What Clem recomended is the answer but remember which rocker stopped the noise and make sure the nut is not to loose and backing off. if the noise returns down the road at the same place you will probably be replacing the cam and the damaged lifter.
        Cam break in on a new engine some times gets neglected. Also the break in lube on the lobes is not good enough. Also some times the rebulder forgets to spin each lifter to make sure it will be able to spin at start up.
        With luck you will get it with the adjustment. I would use 1/4 turn down on the hydraulic lifters instead of the recomended. they run better and it will let you know sooner if you are loosing a cam lobe.

        DOM

        Comment

        • Edward J.
          Extremely Frequent Poster
          • September 15, 2008
          • 6942

          #5
          Re: 64 327 Hydraulic lifter/tappet noise.

          Originally posted by Michael Cornwell (48532)
          My recently rebuilt 327-300 hp with new mild comp cam and all new components runs great until warm when tappet noise starts. Any thoughts?

          Mike, whats the oil pressure doing when the engines hot.

          rechecking the lifter adjustment as prev. posters is a good idea, after zero lash,a full turn on rocker is acceptiable or slightly less. See if you can tell which side is making the noise and pull that rocker cover side first.
          New England chapter member, 63 Convert. 327/340- Chapter/Regional/national Top Flight, 72 coupe- chapter and regional Top Flight.

          Comment

          Working...
          Searching...Please wait.
          An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

          Please push the back button and reload the previous window.'
          An unexpected error was returned: 'Your submission could not be processed because the token has expired.

          Please push the back button and reload the previous window.'
          An internal error has occurred and the module cannot be displayed.
          There are no results that meet this criteria.
          Search Result for "|||"