4 ?s on 1967s

[Keith G.]

Does the left horn wire go through a clip on the radiator support, what does the third black plastic tye from the left go around on the fire wall, are the 4 little bolts on the body mount covers in front of the rear wheels cad or black and does anyone have a picture of the anti rattle THINGS that go under the decklid to keep the locks from rattling when the top is down?

[Keith G.]

Re: 4 ?s on 1967s

#5 Do the screws on the bypass hose clamps have a hex head and a standard screwdriver slot or just a screwdriver slot with a round head.

[Bill I.]

Re: 4 ?s on 1967s

Keith, on # 5, the screws are cad plated, raised round with a crossed slot that will allow a straight or Phillips driver. Bill.

[William C.]

Re: 4 ?s on 1967s

Does the left horn wire go through a clip on the radiator support, what does the third black plastic tye from the left go around on the fire wall, are the 4 little bolts on the body mount covers in front of the rear wheels cad or black and does anyone have a picture of the anti rattle THINGS that go under the decklid to keep the locks from rattling when the top is down?

The driver side horn comes from the wiring harness to the horn. (no clip)
The passenger side goes though a clip on the rad. support to the horn.

3rd tye has harness, wiper hose, hood release cable and purple wire.

4 bolts are cad and could have undercoat on them.

My car was restored by a NCRS judge and Top Flighted in 2009.
Hope this helps.

[John H.]

Re: 4 ?s on 1967s

4 bolts are cad and could have undercoat on them.

My car was restored by a NCRS judge and Top Flighted in 2009.
Hope this helps.

Bill -

Those four screws on the access cover shouldn't have any undercoat on them, nor should the cover; the undercoat was applied in the Paint Shop, and the covers were installed about six hours later, after Body Drop.

[William C.]

Re: 4 ?s on 1967s

Bill -

Those four screws on the access cover shouldn't have any undercoat on them, nor should the cover; the undercoat was applied in the Paint Shop, and the covers were installed about six hours later, after Body Drop.

Thanks John mine doesn't but some where I thought I read they could.

[Keith G.]

Re: 4 ?s on 1967s

John, any help on the other 4 questions.

[Keith G.]

Re: 4 ?s on 1967s

Still need some help, so I thought I would start it over again.

[John H.]

Re: 4 ?s on 1967s

Still need some help, so I thought I would start it over again.

Keith -

I think everything has been covered except for the anti-rattle things; I've never seen any on known-original cars, and they don't show anywhere in the Assembly Manual. They may be owner-inspired, or they might have been on a TSB for the dealers to respond to owner complaints, but I've never seen anything that would indicate that they were ever factory-installed.