68 blade holders
on my 68 which end of the holers should be stamped trico
-
-
Re: 68 blade holders
Joseph - I'd expect both ends of the holder to be stamped TRICO and also have MADE IN USA in small letter directly under the TRICO. Pete -
Re: 68 blade holders
pete thanks when i had the car judged 1st time judges pointed to one end but a set of originals i bought are stamped both ends the shop that has my car was going to check into this and if needed fill in one end now i know not to do this thanks joeComment
-
Re: 68 blade holders
Joe,
Are your 1968 wiper holders 1st design (GM # 3913614, gray finish) or 2nd design (GM # 3938167, black finish)? There should NOT be a letter "R" inside a circle after the "TRICO" stamping like many of the Trico blades made in the late 1970's.
DaveComment
Comment