58 fuelie balancer

[Garry B.]

Re: 58 fuelie balancer

I believe the one on the right is the 3764318 used on the Duntov solid lifter '59 270hp engine as well as the others that Joe mentioned. (I bid on the one on the right and lost at $425 and should have gone higher) I have seen discussions that the other one (left) with the holes on the outer edge were used on passenger cars although I don't have any data to support it. The based engine 3760584 resembles this one but does not have the holes on the outer edge.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=280343036816&sspagename=STRK%3AMEWAX%3AIT&viewitem=#ht_500wt_1427

Garry

[Ken H.]

Re: 58 fuelie balancer

I believe the one on the right is the 3764318 used on the Duntov solid lifter '59 270hp engine as well as the others that Joe mentioned. (I bid on the one on the right and lost at $425 and should have gone higher) I have seen discussions that the other one (left) with the holes on the outer edge were used on passenger cars although I don't have any data to support it. The based engine 3760584 resembles this one but does not have the holes on the outer edge.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=280343036816&sspagename=STRK%3AMEWAX%3AIT&viewitem=#ht_500wt_1427

Garry

Gary,

FYI - I e-mailed the seller on that balancer and they said they still have one available. I would contact them directly if you still want a rebuilt 318 balancer (but be prepared to pay for it).

[Joe L.]

Re: 58 fuelie balancer

I believe the one on the right is the 3764318 used on the Duntov solid lifter '59 270hp engine as well as the others that Joe mentioned. (I bid on the one on the right and lost at $425 and should have gone higher) I have seen discussions that the other one (left) with the holes on the outer edge were used on passenger cars although I don't have any data to support it. The based engine 3760584 resembles this one but does not have the holes on the outer edge.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=280343036816&sspagename=STRK%3AMEWAX%3AIT&viewitem=#ht_500wt_1427

Garry

Garry-----


I thought the 3760584 was a riveted style balancer and otherwise configured with the smaller OD "step" on the front and the larger OD "step" at the rear.

[Karl L.]

Re: 58 fuelie balancer

John,

In my Chevrolet Parts And Accesories Catalog,
Dated 1929-1959... Effective April 1, 1959...

GRP. #0.659 Balancer, Pulley.....
GM#3760584...58-59 All, CORV. (283) (exc. F.I. w/H.L. Cam.)
w/o pulley (hub 4 5/8 O.D.)
GM#3742986...57-59....PASS.,CORVETTE (F.I. w/H.L. Cam.)
w/o pulley

58 CORVETTE ( 1st design) PULLEY, balancer (stamped) 3742991
58-59 CORVETTE (2nd design) PULLEY, balancer (stamped) 3756328

Karl