I just pulled my original head bolts out after 43 yrs of service for a rebuild of my org L-36.
They are a slightly indented head bolt with a prominent "cross" (+) in the center. The ends of the cross extend virtually all the way to the perimeter. The manufacturers id, "M" is seen in one quadrant of the "cross".
Can I clean up and reuse the org bolts or are the repops from CC or Paragon the same head markings for judging and better to go with new bolts steel bolts anyway..........thank-you.
They are a slightly indented head bolt with a prominent "cross" (+) in the center. The ends of the cross extend virtually all the way to the perimeter. The manufacturers id, "M" is seen in one quadrant of the "cross".
Can I clean up and reuse the org bolts or are the repops from CC or Paragon the same head markings for judging and better to go with new bolts steel bolts anyway..........thank-you.
Comment