liscence plate light mounting

[Donald S.]

can someone show me a pic of the three screws /nuts/lock washers that hold the liscence plate light in . are they like a 10-24 screw with a tapered head ? thanks Don

[Mike M.]

Re: liscence plate light mounting

Don, Screws are zinc plated flat head cross recess.
HaND

[Jeff A.]

Re: liscence plate light mounting

Mike,
Try the Long Island on-line catalog. Click 'order online' and punch in part #05-30. Unfortunately, the enlarged picture is pretty fuzzy, but it'll give you an idea.
Cheers!
Jeff

[James W.]

Re: liscence plate light mounting

can someone show me a pic of the three screws /nuts/lock washers that hold the liscence plate light in . are they like a 10-24 screw with a tapered head ? thanks Don

Don,

Here you go, these are on a 26,xxx mile original 1965 coupe photographed at the '08 NCRS National Convention.

Hope this helps.

Best Regards,

James West

[Dan H.]

Re: liscence plate light mounting

James, I was curious about the philips screw that is holding the anodized bezel onto the body. My 63/64 JG says it should be a pan head slotted screw with integral washer. Same pn as a 65 AIM in 64 AIM. Anybody confirm what the license bezel should be held by?
Dan

[Alan D.]

Re: liscence plate light mounting

Dan, I have the 161901 listed as a pan head, cross recess(Phillips) #10-12 5/8" pointed tip. However I have no reference as to where that information came from soooo don't take to bank. Alan

[Mike M.]

Re: liscence plate light mounting

Hi Alan,
Yes, you can take it to the bank.
HaND