1st Design Delco Moraine Calipers

[George D.]

Does anyone know the VIN cutoff for the first design Delco Moraine calipers on 1966 models?

[Joe L.]

Re: 1st Design Delco Moraine Calipers

Does anyone know the VIN cutoff for the first design Delco Moraine calipers on 1966 models?

George-----


ALL 1966 model year Corvettes were equipped with the 1st design calipers. This changed for the 1967 model year. Early 67's used first design; later used 2nd design. When it changed in 1967 I do not know. However, I believe it was fairly early in the model year---like, perhaps, during the first 3 months of production.

[George D.]

Re: 1st Design Delco Moraine Calipers

Joe:

Thank you very much for the information!

[Joe L.]

Re: 1st Design Delco Moraine Calipers

Joe:

Thank you very much for the information!

George-----


All original 1st design caliper halves will have casting number prefix "546". All original 2nd design will have prefix "545". All 3rd design (which are functionally the same as 2nd design) will have prefix "547". Some much later SERVICE 1st design caliper halves may also have the "547" casting number prefix.