Hello to everyone!
This is my first post on the technical discussion board. I am looking forward to learning a lot from all the experts in this forum.
I am in the process of restoring my 1963 convertable that I have had since I was 23. I have completed a frame-off restoration except for the transmission. The shop who did the work could not figure out how to get the T-10 right so I am looking elsewhere for help. It will shift from 1st to 3rd but not into 2nd when the engine is running. I was told that 2nd gear and the shaft it is on were quite worn. They replaced most of the internal parts including synchros but not any of the gears(why I don't know). I took it out of the car and now want to find someone who can restore it correctly so I only have to put it back in once. Any direction would be very helpful.
This is my first post on the technical discussion board. I am looking forward to learning a lot from all the experts in this forum.
I am in the process of restoring my 1963 convertable that I have had since I was 23. I have completed a frame-off restoration except for the transmission. The shop who did the work could not figure out how to get the T-10 right so I am looking elsewhere for help. It will shift from 1st to 3rd but not into 2nd when the engine is running. I was told that 2nd gear and the shaft it is on were quite worn. They replaced most of the internal parts including synchros but not any of the gears(why I don't know). I took it out of the car and now want to find someone who can restore it correctly so I only have to put it back in once. Any direction would be very helpful.
Comment