C-1 Power Top Parts

[William B.]

I recently acquired a 1961 Corvette That needs a lot of help. After the purchace I discovered thet it has the Power Top option. I suppose, at some distant time it quit working, and the then owner disconnected it. I have been looking at what it might need to get it operational and have found that there are at least two parts that are missing.
From the AIM for a 1961, the parts I need are the deck lid support arm (3736197) and the lever (3744156) that attaches to it. Also the pin (3736218) and the bushing (4613551) that attaches the support to the piston.
Does anyone know of a source for these parts.
Bill

[Stuart F.]

Re: C-1 Power Top Parts

Bill;

Guess no one else has had a power top C-1.

Stu fox

[Roy B.]

Re: C-1 Power Top Parts

Some parts are repro'ed but not what your asking about , you'll need to locate used ones/

[William B.]

Re: C-1 Power Top Parts

Some parts are repro'ed but not what your asking about , you'll need to locate used ones/

Roy:
Do you know of anyone that might have the 3736197 support and the 3744156 lever that I might borrow or get sketches/pictures from for duplication?
Recently there have been two separate sets of parts on eBay and both offerers said that they would take pictures and/or make sketches, but as yet, I have not heard back . Interestingly, the one that sold went to an eBay member in the Netherlands.
Thanks for the reply,
Bill Babb

[Rob M.]

Re: C-1 Power Top Parts

Interestingly, the one that sold went to an eBay member in the Netherlands.

As long as it is a Dutch Chapter member it is not too bad...

[Roy B.]

Re: C-1 Power Top Parts

Roy:
Do you know of anyone that might have the 3736197 support and the 3744156 lever that I might borrow or get sketches/pictures from for duplication?
Recently there have been two separate sets of parts on eBay and both offerers said that they would take pictures and/or make sketches, but as yet, I have not heard back . Interestingly, the one that sold went to an eBay member in the Netherlands.
Thanks for the reply,
Bill Babb

Those are not easy parts to repro, some one here NCRS restores PT's may have extra parts,how about asking Vette gal or that Ray person on e-bay (send a e-mail) Dont some one in Southern Ca. NCRS or SACC have a powewr top to look at???