There was a thread started earlier regarding the Big Block end seals. In it there was some communication about whether or not a deduction should be taken for not having the GM logo tabs. I believe there is some confusion or lack of knowledge when it comes to Big Block intake gaskets.
I stated in the thread that it is impossible to see the GM logo in the rear and it is definitely impossible to see in the front since the tab is inside the intake valley. The car in question received a 1 point deduction. I don't know how the judges got to a full 1 point deduction on this and I would love to see them work out the math. Regardless, I thought I would post a few photos of the end seal uninstalled and installed on a 65 Big Block engine. Photos are attached. I would entertain a conversation on this if anyone has any thoughts, questions, additional information or photos.
I stated in the thread that it is impossible to see the GM logo in the rear and it is definitely impossible to see in the front since the tab is inside the intake valley. The car in question received a 1 point deduction. I don't know how the judges got to a full 1 point deduction on this and I would love to see them work out the math. Regardless, I thought I would post a few photos of the end seal uninstalled and installed on a 65 Big Block engine. Photos are attached. I would entertain a conversation on this if anyone has any thoughts, questions, additional information or photos.