'63 rivet update

[Jack H.]

Hi y'all,
After a long delay for various reasons I been working on the '63. Jig fixtures for holding the upper and lower control arms they have been fabbed. Did a test rivet on an old ball joint today and believe it will work out and pass judging, at least I hope so. With 1 rivet installed the ball joint held when tapping with a punch and hammer. What do y'all think, opinions welcome. Thanks Jack
DSC05765.jpg DSC05764.jpg

[Jack H.]

Another pic with paint removed from old ball joint...should have done that befor rivet lol DSC05766.jpg

[Alan D.]

So here is an original however it's on a Mar 64, your grease fitting is correct, change happened later in 1964
BJlfUp2.jpg

[Jack H.]

So here is an original however it's on a Mar 64, your grease fitting is correct, change happened later in 1964
BJlfUp2.jpg

Thanks, don't think it's to far off for my first attempt