Let me first state that my VIN production number is 000286. I only state this, as I have found a couple of 63 carryover applications because it was so early in the 1964 production run. 1964 NCRS Technical Manual (Spring 1998), Page 114 - e. states there are 3 push-in post type plugs on each side of the inner fenders. I'm OK on the headlamp harness side, but somewhat befuddled on the right side. Thus, wondering if someone could tell me where the push-in plugs are located. I have one hole across from where the middle push-in is located on left side. But, no hole for one on either side of that one. I do see a hole toward the front and hope I can get a picture posted of that hole. If that is not used for a push-in, then what is it for. In looking at that hole on the right side, be it known that I have put a 67 Stinger hood on the car, so the hood support is located on the left side rather than the right side.
IMG_2991.jpg
IMG_2991.jpg
Comment