C! Decklid Holes for HardTop

[Sheldon S.]

I,m wondering if someone has some measurements for the three holes for securing the hardtop to the deckled. My car is a 1956 but assuming at least to 60 they might be the same. I have a pic of how I measured mine
.
.IMG_1476.jpgIMG_1474.jpg

[Kent S.]

Re: C! Decklid Holes for HardTop

I would recommend you wait until the car is assembled and mount the actual hardtop you're going to use to mark the holes. Being off by just a little when the car is complete and you attempt to mount the top is a problem you don't want to deal with.

[Mike M.]

Re: C! Decklid Holes for HardTop

agree with Kent. mike

[Sheldon S.]

Re: C! Decklid Holes for HardTop

Thanks Kent and Mike
Where the moulding goes there are the four larger holes on each side to attach molding, but the deckled also has a bunch of small holes that screws were in. I don't think those should be there and was going to fill or am I forgetting something

Sheldon

[Steven B.]

Re: C! Decklid Holes for HardTop

Thanks Kent and Mike
Where the moulding goes there are the four larger holes on each side to attach molding, but the deckled also has a bunch of small holes that screws were in. I don't think those should be there and was going to fill or am I forgetting something

Sheldon

Small holes for tonneau fasteners?

[Kent S.]

Re: C! Decklid Holes for HardTop

Small holes for tonneau fasteners?

I agree - popular addition back in the day.

[Rod K.]

Re: C! Decklid Holes for HardTop

And my question is why the two larger holes just inside the rear corners of the deck lid? '61-'62 mounting points??