Jute padding layout

[Michael L.]

Guys,

I'm laying down the jute to go under my carpet and I'm trying to figure out where all the pieces go. I've laid them out and the two in the front seem obvious as do the two for the rear deck but I'm trying to figure out the middle pieces. do I have them laid out correctly? Also, what's the purpose of the cutouts in the front pieces, and do I just stick them in where they were cut out of? Please see attached pic.

Mike

jute.jpg

[James G.]

Re: Jute padding layout

Guys,

I'm laying down the jute to go under my carpet and I'm trying to figure out where all the pieces go. I've laid them out and the two in the front seem obvious as do the two for the rear deck but I'm trying to figure out the middle pieces. do I have them laid out correctly? Also, what's the purpose of the cutouts in the front pieces, and do I just stick them in where they were cut out of? Please see attached pic.

Mike

[ATTACH=CONFIG]111437[/ATTACH]

I believe the rectangle(ish) cutouts are for 1972-up seat belt retractors.

[Michael L.]

Re: Jute padding layout

OK so does that mean that those go under the seats and the ones I have in the middle go up front?

[James G.]

Re: Jute padding layout

Under the seat with the cut out area closer to the rocker VS trans tunnel.

[Michael L.]

Re: Jute padding layout

Thanks James. I posed this question to Paragon's tech guys (they can be reached at tech@paragoncorvette.comjute.jpg