69 Front center re-enforcement rod hits bumper brace
Hi everyone,
I attached assembly manual page (11-13) for reference. Rather than sitting flush on the front area where it bolts up the re-enforcement rod hits the top of the bumper brace leaving about 1/8 to 3/16" gap. Everything is bolted up correctly and nothing appears bent. Unfortunately I didn't notice how it was situated before I removed it. Wondering if anyone else has seen the same? From View A of the photo this is the front of rod #9 hitting bumper brace.
Thanks,
Jack
I attached assembly manual page (11-13) for reference. Rather than sitting flush on the front area where it bolts up the re-enforcement rod hits the top of the bumper brace leaving about 1/8 to 3/16" gap. Everything is bolted up correctly and nothing appears bent. Unfortunately I didn't notice how it was situated before I removed it. Wondering if anyone else has seen the same? From View A of the photo this is the front of rod #9 hitting bumper brace.
Thanks,
Jack