69 Tee Fitting from Wiper Motor to Windshield Washer Hoses

[Wes G.]

Referring to the attached 69 Assembly Manual Dwgs (1/D6 & 1/D7) with regards to the Tee (or Y ?) highlighted in orange, can anyone provide me with any or all of the following: GM #, sizing (OD of ports), configuration (T or Y), picture??
Thanks
Wes

[Joe L.]

Re: 69 Tee Fitting from Wiper Motor to Windshield Washer Hoses

Referring to the attached 69 Assembly Manual Dwgs (1/D6 & 1/D7) with regards to the Tee (or Y ?) highlighted in orange, can anyone provide me with any or all of the following: GM #, sizing (OD of ports), configuration (T or Y), picture??
Thanks
Wes

Wes------

The component about which you inquire was discussed in another recent thread on this board and was referred to as a "barrel valve" although I do not believe that's its official designation. As far as I can tell, it was never available in SERVICE from GM. I'm sure it had a part number but since it was not available in SERVICE such a number would be of little use. It may have been part of hose assembly GM #3940536 which was also never available in SERVICE.

It is a T configuration. The two output ports are barbed and of 0.118" OD X 1/2" in length. The single input port is 0.250" OD and I do not think it is barbed.

[Wes G.]

Re: 69 Tee Fitting from Wiper Motor to Windshield Washer Hoses

Thanks Joe. Much appreciated, that's exactly what I was looking for. I can't believe I missed that post (right next to my post after all that searching), I guess that "Barrel Valve' description threw me off-sorry that's the best excuse I can offer