63 clutch pedal push rod - NCRS Discussion Boards

63 clutch pedal push rod

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Frank D.
    Expired
    • December 27, 2007
    • 2703

    63 clutch pedal push rod

    The AIM shows a washer at both the Z-bar (barrel swivel) engine bay side under the "G" clip and another at the cockpit pedalbracket where the other end of the rod goes on the shaft. I have only one "wave" washer - are these used on both ends or just one ? And if so, which end...and is the other washer on the other end just a flat one ?

    And does the washer in the engine bay go between the swivel and the Z-bar or between the "G" clip and Z-bar ?
  • Richard G.
    Extremely Frequent Poster
    • July 31, 1984
    • 1715

    #2
    Re: 63 clutch pedal push rod

    Frank
    Best I can tell from the assembly manual a wave washer is used between the clutch rod and the pedal. It goes between the rod and the pedal bracket.
    On the lower end of the clutch rod it isn't as clear in the drawing. However, it clearly indicated, in the call out, the 3834560 washer (wave washer, I suspect) at the bottom end.
    Looks like you will need two of them. Be sure to insert the rod from the correct side. The G washer is on the inside, at the Z bar on the rod from the pedal. And the clutch rod enters the "Z" bar from the engine side. I believe the direction the clutch rod enters the "Z" is unique to the 63.

    Attached Files

    Comment

    Working...
    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"