Need ID on the screw type that retains the vent handles to the dash. 1963

[Richard G.]

Need help to ID the screws that retains the vent handles to the dash.
There are two in each handle. They go in upside down and screw into the lower dash area.
I have no idea what they might look like.


Theoretically it would have been much easier to put the screws back in the holes they come of of!
And no I didn't take is apart.
Any help here would be appreciated.

[Frank D.]

Re: Need ID on the screw type that retains the vent handles to the dash. 1963

I don't think my 63 screws are correct now that I see what Long Island Corvettes sells for the 63/64 years:

[Richard G.]

Re: Need ID on the screw type that retains the vent handles to the dash. 1963

Frank;
It is my nature to go with what is in your car not the catalog. However I failed to check LIC.
Lacking any other information I will order some. LIC seems to be a great source for my C2 needs. However sometimes they miss the mark. The license plate attachment screw is one example. Bolts and screws have to be a real pain for the re-sellers. Lots of different accepted GM parts and the running changes. Thank you for your time in checking on this.
LIC also have this clip for the passenger side vent cable in the catalog for $5. Unsure where it goes but I will check on assembly manual.

[Bob W.]

Re: Need ID on the screw type that retains the vent handles to the dash. 1963

Richard , What is the part number of the clip at LIC as I may need one also.

Thanks Bob

[Richard G.]

Re: Need ID on the screw type that retains the vent handles to the dash. 1963

CABLE CLIP- HEATER TO RH VENT CABLE (UNDER DASH)
39-07C is the part number.

[Bob W.]

Re: Need ID on the screw type that retains the vent handles to the dash. 1963

Richard , Thanks for the photo and number.

Bob

[Frank D.]

Re: Need ID on the screw type that retains the vent handles to the dash. 1963

CABLE CLIP- HEATER TO RH VENT CABLE (UNDER DASH)
39-07C is the part number.

Uh - in general, where does this go ?
Not near my AIM and I don't remember it on my May 63 car...

[Richard G.]

Re: Need ID on the screw type that retains the vent handles to the dash. 1963

Might be needed on a later car? Catalogs lie like dogs...
I really don't know other than it is listed as required.

[Frank D.]

Re: Need ID on the screw type that retains the vent handles to the dash. 1963

Might be needed on a later car? Catalogs lie like dogs...
I really don't know other than it is listed as required.

Ha! - You mean like the rubber gaskets that go under the door locks ?

[Bob W.]

Re: Need ID on the screw type that retains the vent handles to the dash. 1963

Richard/Frank I couldn't find it either, maybe it was in the glove box for dealer install like the door lock gaskets and they didn't install on our cars.