I just got my ignition shielding set that I ordered a while ago and was excited about getting it on the engine. they are all original pieces, restored. but since I didn't have any shielding when I bought the car, I can't be sure that it is correct and could use some help on a couple of issues.
In general, the pieces look verygood for original and restored pieces. All but the top cover (a bit more hazy chrome) has the samefinish and in general look to be good quality.




There are two wire brackets that go in the uprights to hold the 4 wires from each side in the rear upright pieces. One is cad plated looking, the other is painted black. Are these the correct finishes?
Thanks for your help folks.
Rich
In general, the pieces look verygood for original and restored pieces. All but the top cover (a bit more hazy chrome) has the samefinish and in general look to be good quality.
There are two wire brackets that go in the uprights to hold the 4 wires from each side in the rear upright pieces. One is cad plated looking, the other is painted black. Are these the correct finishes?
Thanks for your help folks.
Rich
Comment