C2 radio side panel screws

[Ralph P.]

Anyone know a source for the original type screws ? The incorrect captive-washer screws seem to be all that are sold...

[Gene M.]

Re: C2 radio side panel screws

Ralph,
If you want correct screws look for originals at Carlisle. Replacements are just that replacements, not correct.

[Leif A.]

Re: C2 radio side panel screws

Ralph,
I'm not near my TIM&JG but what is the birth date of your car? I seem to recall that later model '67 used the captive washer screws for the radio side panels.

[Ralph P.]

Re: C2 radio side panel screws

Thanks, Lief,,,, mine's a very late production ( June 29th)

[Alan D.]

Re: C2 radio side panel screws

Does the 67 AIM show a different pn and if so what's the ECN date?

[Leif A.]

Re: C2 radio side panel screws

According to the 5th edition TIM&JG for the '67 model, the radio side trim panels are "retained at the top front and rear with two chrome Phillips screws with integral washers". The picture shown in the TIM&JG are very similar to the attached pic found in the LIC website #44-12.

[Frank T.]

Re: C2 radio side panel screws

If you want real ones David sakoloski 310 329 5334 or Richard 810 845 6763

[Gerard F.]

Re: C2 radio side panel screws

Ralph,

Here's a pic of one of my radio panel screws for a 67 vin 22049 (June 29):

RadioSidePanelscrew67 (Medium).jpg

My side panels are replacement for Vintage Air, but the screws are original. They look like the LIC photos Leif posted.

What is the VIN of your car, it must be pretty close to mine with a June 29 assembly?

[Tracy C.]

Re: C2 radio side panel screws

According to the 5th edition TIM&JG for the '67 model, the radio side trim panels are "retained at the top front and rear with two chrome Phillips screws with integral washers". The picture shown in the TIM&JG are very similar to the attached pic found in the LIC website #44-12.

Those look just like the sheet metal screws available at Lowes or Home Depot.

[Ralph P.]

Re: C2 radio side panel screws

Thanks, Jerry
Mine is 21886( BUT, the date is K27 not 29 ) Yes, those screws look original. I have 2 of the originals from my car , but, others had been replaced with the common hardware type.

[Enzo C.]

Re: C2 radio side panel screws

Gents the king of screws is Rich Pasqualone and he has any screw , nut and original bolt you may need. He is also all over Ebay . Hic cell number is 610-462-4441. I'm sure that many members know Rich. Good luck

[Jim D.]

Re: C2 radio side panel screws

I don't know about 67's but I had to replace the tarnished ones on my 65 and the ones from LICS were exactly the same as my originals.

[Joe R.]

Re: C2 radio side panel screws

Gentlemen, there is nothing rare about these screws. Every vendor on the planet has correct screws for the radio side panels. Just call your favorite vendor and enjoy.

JR