'67 with factory A/C. New harness installed a year ago and these two wires are not attached anywhere. Please look at the location in the attachments and give me your ideas. Possibly part of a universal harness and not used with an A/C car?? The double black wire has a spade connection and the red wire has an end that resembles a fuse holder. I've looked all around the immediate area and can't see where these would mate up with anything. AIM, UPC C60, E9 attached...not doing me any good. A/C and blower motor both work fine. Thanx in advance.
-
Leif
'67 Coupe L79, M21, C60, N14, N40, J50, A31, U69, A01, QB1
Top Flight 2017 Lone Star Regional -
Re: Extra Wires - '67 with C60
Leif ,
Those are extra leads not used because of the additional A/C harness , Can't say for sure in the 67 AIM , but in the 66 AIM that is vaguely covered on UPC C-60 , E-1, #8 . It says to tape them up and tuck them under the fender .
If it is not in your 67 Aim , let me know and I will snap a photo of my 66 AIM page for you , if you want.
JimLast edited by Jim S.; August 19, 2015, 09:54 PM. -
Re: Extra Wires - '67 with C60
Jim,
Thank you for your prompt reply. No pic of the AIM necessary...I'll just use some electrical tape and do as you describe. BTW, the '67 AIM has the same notation. I couldn't make sense out of the #8 notation until you described what that meant. Thanks, again.Leif
'67 Coupe L79, M21, C60, N14, N40, J50, A31, U69, A01, QB1
Top Flight 2017 Lone Star RegionalComment
Comment