Question for Joe Lucia or other, A/C compressor 5 3/4" pulley application?

[Domenic T.]

Did other HP GM cars use the 5/34" A/C compressor pulley?
I know the C2 corvettes used them except for the 365 HP 327, but who else used them, or are they exclusive to our corvettes?

Dom

[Wayne M.]

Re: Question for Joe Lucia or other, A/C compressor 5 3/4" pulley application?

Did other HP GM cars use the 5/34" A/C compressor pulley?
I know the C2 corvettes used them except for the 365 HP 327, but who else used them, or are they exclusive to our corvettes?

Dom

More like what GM cars did NOT use the 5_3/4" dia. A/C pulley in the '62-'68 era, (aka Delco # 15-216, or GM # 5914745). Should be plenty around.
The smaller 4_3/4" pulley (Delco 15-224) used for '69-up, depending on vehicle/motor .

[Domenic T.]

Re: Question for Joe Lucia or other, A/C compressor 5 3/4" pulley application?

Wayne,
Thanks, they are getting hard to find. That may explain the corvette compressors I get in that do not have the dished low compression pistons. I know that the internals can get switched somewhere down the line but a lot of compressors are sold a vette compressors. The compression is not a promlem if used on a vette
but the manual does state the difference as to compression.
Again thanks for the reply, gives me info that is needed.

DOM