tach on 60 vette - NCRS Discussion Boards

tach on 60 vette

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Joe C.
    Very Frequent User
    • April 30, 2001
    • 126

    tach on 60 vette

    went to install my tach on my 60 corvette. Everything seemed to check out fine when I checked it out with dash outside of car. when I installed the dash, the tach needle spun around and came off. Obviously it didn't work. Did I install wrong? what could have caused this tach to not wrong properl? Any suggestions any suggestions how to install proI perly. thanks.
  • Jack H.
    Extremely Frequent Poster
    • April 1, 1990
    • 9906

    #2
    Re: tach on 60 vette

    Sounds like the pointer needle was loose on the tach's drive shaft... Should take a rather hard/firm push to get it seated.

    Comment

    • Joe C.
      Very Frequent User
      • April 30, 2001
      • 126

      #3
      Re: tach on 60 vette

      thanks but what would make the tach needle spin around like that? Is there some way the tach needs to be installed? or is it justa loose needle.

      Comment

      Working...
      Searching...Please wait.
      An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

      Please push the back button and reload the previous window.'
      An unexpected error was returned: 'Your submission could not be processed because the token has expired.

      Please push the back button and reload the previous window.'
      An internal error has occurred and the module cannot be displayed.
      There are no results that meet this criteria.
      Search Result for "|||"