I probably should not have posted my question on top of Joes thread. I apoligize. Here is my experiance with re-bonding the inner hood support and my question.
I have just "glued" the hood on my 65 back together. I went to NAPA, Auto Zone and others and nobody had "hood mastic" or gumdrops. Based on information I found in the archives I went to Lowes and after reading the labels on about 20 different tubes, settled on an adhesive that said fiberglass and stays flexible. It took 3 days to set up, but I think it will work out ok.
Now for my question, Bubba had solved the problem by using pop rivets which I drilled out and am in the process of filling. Can someone post a photo of the inner hood panel, I think the holes are supposed to be in the tabs where you put the adhesive but I don't know. There are two holes in each large tab, and 1 hole in the smaller ones.
Thank you in advance,
George
I have just "glued" the hood on my 65 back together. I went to NAPA, Auto Zone and others and nobody had "hood mastic" or gumdrops. Based on information I found in the archives I went to Lowes and after reading the labels on about 20 different tubes, settled on an adhesive that said fiberglass and stays flexible. It took 3 days to set up, but I think it will work out ok.
Now for my question, Bubba had solved the problem by using pop rivets which I drilled out and am in the process of filling. Can someone post a photo of the inner hood panel, I think the holes are supposed to be in the tabs where you put the adhesive but I don't know. There are two holes in each large tab, and 1 hole in the smaller ones.
Thank you in advance,
George
Comment