Dear Members,
My original console is very pitted and I may trade for a better one plus $. I am looking at #3860149 and I am wondering about putting back in the power window switch. This one doesn't have the hole, but I see the studs on the bottom for the screws. I see that CC has the rivets to put back the switch cup. If I make a stencil, will a Dremel tool with a small cut-off work to get through the cast metal. Has anyone done this before? What's the best method? Thank you much!
Justin #41362
My original console is very pitted and I may trade for a better one plus $. I am looking at #3860149 and I am wondering about putting back in the power window switch. This one doesn't have the hole, but I see the studs on the bottom for the screws. I see that CC has the rivets to put back the switch cup. If I make a stencil, will a Dremel tool with a small cut-off work to get through the cast metal. Has anyone done this before? What's the best method? Thank you much!
Justin #41362
Comment