I recently replaced the old drive cable because my tach was acting funny (not reading right and being real erratic). I figured I would test it by hooking it up to a drill and running it, but when I did, it did absolutely nothing. Does the ignition have to be on (I havent tried this, because I just put in a new motor and havent hooked up the wiring), or is my tach faulty? Is there anyway to fix it without pulling the cluster out? Thanks, Dan
- If this is your first visit, be sure to check out the FAQ You must be an NCRS member before you can post: click the Join NCRS link above to join. To start viewing messages, select the forum that you want to visit from the selection below. If you have trouble logging in you can clear your cookies here!
Comment