I have a C3 (1974) vette and i need to remove the ignition lock cylinder. I've taken off the steering wheel and the directional signal switch, but i can't get the lock out... My manual (Corvette 1966-1982 Shop Manual) tells me that I need to stick a small flat tool into this slot, but I can't figure out which slot they're refering too. There are only two slots that I can see that reach to the cylinder, but neither of them has anything to press on with the flat tool... any suggestions?
Btw my manual says: "Insert a small screw driver or similar tool into the turn signal housing slot. Keeping the tool to the right side of the slot, break the housing flash loose and at the same time depress the spring latch at the lower end of the lock cylinder. With the latch depressed, the lock cylinder can be removed from the housing."
thanks
Btw my manual says: "Insert a small screw driver or similar tool into the turn signal housing slot. Keeping the tool to the right side of the slot, break the housing flash loose and at the same time depress the spring latch at the lower end of the lock cylinder. With the latch depressed, the lock cylinder can be removed from the housing."
thanks
Comment