Front sits too high after rebuild

[Tom Freeman]

front sits too high after rebuild tom freeman recently rebuilt the front end on my ' conv now it sits too high was etting somewhat hight to start with the top of the finderwell was at inches should be per aim now it is at inches during reassembly made sure that the springs reused the stock springs were in their pockets and did not tighten down the a arm bushing bolts until the car was on the ground infact they still just finger tight any suggestions hate to have to go back in and cut a loop off of the springs tom

[Gene M.]

Re: Front sits too high after rebuild

re front sits too high after rebuild gene manno make sure you did't assemble the springs upside down there is a notch on the end of the top coil