How can I tell the difference between a D310 and a D308. I know that the D310 is for fuelly's, and therefore the towers are shorter for clearance. I have what I believe is a D308, But how can I tell without comparing the two side by side? Any help would be appreciated. Brian
-
-
Re: C2 Delco Remy dist. cap
Put a micrometer on the outside edge of any outer plug wire tower. If it's the D308 'tall' dist cap, you should measure about 0.900 inches from the outside lip to the upper flange. If it's the D310 'shortie' dist cap, it'll be significantly less distance (around 3/4-inch).... -
Re: C2 Delco Remy dist. cap
Jack, I don't have a micrometer could this be done using a ruler, say that goes to 1/64 of an inch?
Do I measure from the innermost part of the tower?Comment
-
Re: C2 Delco Remy dist. cap
Jack I measured to the outside edge I get about 58/64", it looks like I have the "tall" one.
Thanks for your help-BrianComment
-
Re: C2 Delco Remy dist. cap
Sorry about the brain f--t, I knew what you were talking about the first time.
Thanks again-BrianComment
Comment