1960 Radiator Support Seals - NCRS Discussion Boards

1960 Radiator Support Seals

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Joe M.
    Extremely Frequent Poster
    • April 30, 1990
    • 1338

    1960 Radiator Support Seals

    I figured out where to glue the corner pieces, but the long piece does not seem to be wide enough to fill the gap between the bottom of the radiator and the radiator support.

    Where do I glue the long piece on the radiator support and how much gap should remain between the bottom of the radiator and the top of the rubber seal?

    I estimate there will be at least 1 inch gap depending on where I glue it. Is my repro radiator shorter than the original?

    I attached a photo of the gap without a seal.
Working...
Searching...Please wait.
An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

Please push the back button and reload the previous window.'
An unexpected error was returned: 'Your submission could not be processed because the token has expired.

Please push the back button and reload the previous window.'
An internal error has occurred and the module cannot be displayed.
There are no results that meet this criteria.
Search Result for "|||"