Noticed that the lead screw on the jack has a drift pin in it on the other side of the nut (also held by pin). Does any one know the length of this pin (dia=0.1") From all photo's I've seen it extends past the shaft on each side.
Also, what finish was it - black paint, zinc, black phos, ??
Now that I'm asking the last detail question to finish the jack - I did a search and looked at the Restorer, but unable to tell. However I did discover all the work of the past two days was on a Type III jack, naturally I need a Type I - so back to painting.
Thanks
Alan
Also, what finish was it - black paint, zinc, black phos, ??
Now that I'm asking the last detail question to finish the jack - I did a search and looked at the Restorer, but unable to tell. However I did discover all the work of the past two days was on a Type III jack, naturally I need a Type I - so back to painting.
Thanks
Alan